Why Do Products Produced By Thermoforming Machines Sometimes Have Cooling Marks?

Oct 16, 2024

Leave a message

Why do products produced by thermoforming machines sometimes have cooling marks?

 

The so-called cooling marks refer to the unexpected protrusions on the products produced by the thermoforming machine, which can affect the appearance and symmetry of the products. Cooling marks are unwelcome defects, so what are the main reasons for the formation of cooling marks?

During the stretching process in the preform stage, the sheet material is accidentally subjected to strength cooling, resulting in the formation of cooling marks.

Cooling due to contact with the following components:

1. Contact with molded mold components

2. Contact with the stretching plunger

3.In some cases, the heated sheet may encounter an uneven highly compressed airflow during the pre forming process.

When the heated sheet comes into contact with the mold, heat conduction causes cooling, and rapid cooling leads to the formation of cooling marks. The several important parameters affected are as follows:

1. Temperature difference between the contact point between the molding mold component and the thermoplastic sheet, as well as the temperature difference between the pre stretched plunger and the contact point of the thermoplastic sheet

2. Contact time

The above are the main reasons for cooling marks on plastic products. So, what are the methods to reduce cooling marks?

1. Reduce the temperature difference between the forming section and the contact point of the thermoplastic sheet, as well as the temperature difference between the pre stretched plunger and the contact point of the thermoplastic sheet, thereby reducing cooling marks.

2. Reduce contact time.

3. Maintain continuous stretching.

Send Inquiry